Ink for screen printing on fabric is an ink that can be used for screen printing or pad printing. It is resistant to hand sweat, alcohol and abrasion. It has strong adhesion on the material of fabric.
Product name: Ink for Screen Printing On Fabric
Product number: XG-136M
Ratio: add 100g silicone ink with 10g XG-KB
Curing Method: Room temperature cure
Introduction to ink for screen printing on fabric
Ink for screen printing on fabric features:
1: It is resistant to hand perspiration.
Press your thumb on the printed pattern and rub it back and forth for 100 times. The ink doesn't fade.
2: 3M adhesive tape can't be pulled off.
Use American 3M adhesive tape to stick on the ink pattern, continuously pull 10 times, the ink does not pull off.
3: Screen printing does not block the screen.
1.3mm high small text can also be clearly printed on the pen holder, the yield rate increased by 1.5 times.
4: Pad printing without drawing.
During pad printing, the rubber head does not draw, and there is no ink left on the surface of the steel plate, so the efficiency is increased by 1.2 times.
5: Alcohol resistance test.
The ink did not fall off after 100 times of rubbing with 500g force.
6: Green environmental protection.
The ink meets the requirements of environmental protection regulations of EU, USA and Japan.
7: Factory direct sales.
Liande adopts ISO quality management system, with stable product quality and fast delivery speed.
1. Room temperature cure without table oven
2. Save cost
3. Matte finish
4. High anti-abrasion
5. Pass OEKO TEX100, NIKE RSL, ADIDAS A01-2019, REACH
6. Friendly environment
Q: How will we do the best job for silk screen printing fabric with silicone ink?
A: The silicone ink is two component ink. Please add 10% catalyst by the weight of silicone ink, pigment, reducer. You must mix them thoroughly before screen printing silicone ink.
Q: How will we print the silicone ink on nylon, 100% polyester with high fastness?
A: Please print the silicone adhesive from us. The silicone adhesvie is XG-360Z-3 (its catalyst XG-360Z-3B, add 5% catalyst XG-360Z-3B by the weight of silicone adhesive during screen printing). Please flash every print layer with table oven or dryer before next screen printing. When you finish screen printing glossy or matte finish, please place your product in the oven for 100℃, 10-15 minutes.
Q: Do you have silicone adhesive for room temperature cure?
A: Yes. The silicone adhesive is XG-80C1, XG-200C1. They are light white paste.